Create DHCP Binding Table Entries

Use the following procedure to add entries for devices with static IP addresses to the DHCP binding table.

Procedure

  1. In the navigation pane, expand Configuration > IP.
  2. Select DHCP Snooping.
  3. Select the DHCP Bindings tab.
  4. Select Insert.
  5. In VlanId, type the VLAN ID.
  6. In MacAddress, type the MAC address of the DHCP client.
  7. In AddressType, select a value.
  8. In Address, type the IP address of the DHCP client.
  9. In Interface, select a port.
  10. In LeaseTime(sec), type the time in seconds.
  11. Select Insert.
  12. Select Apply.

DHCP Bindings Field Descriptions

Use data in the following table to use the DHCP Bindings tab.

Name

Description

VlanId

Specifies the VLAN to which the DHCP client belongs.

MacAddress

Specifies the MAC address of the DHCP client.

AddressType

Specifies the type of address. The default address type is IPv4.

Address

Specifies the IP address assigned to the DHCP client.

Interface

Specifies the interface to which the DHCP client connects.

LeaseTime(sec)

Specifies the lease time (in seconds) of the particular DHCP binding entry. The time range is 0 to 2147483646 seconds.

TimeToExpiry(sec)

Species the time of expiry (in seconds) of the DHCP binding entry.

EntryType
Specifies the type of the DHCP binding entry.

  • If the entry was created through DHCP snooping, the type is learned(1).

  • If the entry was created through a management operation, the type is static(2).
9039040-00 Rev AB